A Wallingford, Connecticut neighborhood of older two-storey colonial houses with steep gable roofs and painted clapboard siding behind a stone wall.

Roofing in Wallingford, CT

Water stain on your ceiling, shingles on the lawn after a storm, or ice along the roof edge every winter? New Haven Roofing Co. is a family-owned and operated company that repairs, inspects, and replaces roofs for homeowners in Wallingford. We check your shingles, flashing, and deck from the roof and the attic before we recommend any work. Call us or request an estimate today.

Request a Quote

Services in Wallingford

Most homes in Wallingford are single-family detached houses. On those jobs we work directly with you, stage the dumpster in your driveway, and run the job from start to cleanup without an association in the middle. We work on houses from the streets around Community Lake Park on Hall Avenue and Doolittle Park on South Elm Street out to Gaylord Farms Road above the Quinnipiac River Valley.

For roof repair, we replace missing, curling, or cracked shingles, reset nail pops, and fix leaks at chimneys, skylights, and pipe boots. When flashing has rusted or pulled loose, we replace it with matching flashing material instead of covering it with another bead of caulk.

For roof replacement, we tear the roof off down to the deck. We replace soft or rotted decking, then install drip edge, ice and water shield, synthetic underlayment, new flashing, and architectural shingles or standing seam metal. We finish with ridge vent where the attic needs exhaust.

For roof inspection, we check for granule loss, nail pops, deteriorated underlayment, and moisture in the deck. We photograph what we find so you can see the problem we are describing.

We also handle roof maintenance, including debris removal, moss and algae treatment, and resealing around penetrations. For gutter installation, we hang seamless aluminum gutters pitched to the downspouts and repair the fascia board behind them first. On flat porch roofs and additions, we install EPDM, TPO, and modified bitumen membranes.

A steep gable roof on a two-storey colonial freshly covered in weathered-wood architectural shingles with new step flashing along a brick chimney.

How Local Conditions Affect the Work

Ice dams change how we build the lower edge of a Wallingford roof. Meltwater that backs up behind ice at the eave runs under shingles and into the wall and ceiling below. On a replacement, we run ice and water shield from the drip edge up the roof past the line of the warm wall, and we lap it into the valleys. That membrane seals around each roofing nail, so water held behind an ice dam has no easy way through.

The membrane handles the water. The attic handles the cause. We go into the attic and check whether insulation is packed into the soffit vents and blocking air. We check whether the attic has enough intake at the soffits to feed the ridge vent. A cold, ventilated roof deck keeps the snow from melting unevenly. If the gutters are clogged or sagging, ice builds in them and adds weight at the edge, so we clear them, reset the pitch, and refasten them to the fascia.

Wallingford has older homes with aging roofs, many of them already re-covered at least once and some carrying a second layer of shingles over the original. We count layers at the roof edge before we price a job. A second layer adds tear-off time and disposal weight. It can also hide old flashing that was left in place during the last re-roof. We expect to find tired step flashing at sidewalls and chimneys on these houses, and we plan to replace it.

Wallingford's building department reviews building and demolition permits. For replacement work, we prepare the permit paperwork before we put your tear-off on the calendar. The office is open Monday through Friday, from opening to close, so we file early and set your start date once the permit is in hand.

Rolls of copper-coloured aluminum step flashing, tin snips, a hand seamer and a flat bar laid on a canvas drop cloth on a porch floor.

How We Do the Work

You call or send a request that describes the leak, the missing shingles, or the ice buildup at your roof edge. We walk the roof, check every penetration, and inspect the attic with a light for stains, wet sheathing, mold, and blocked vents. We separate a single failed flashing from a roof that has worn out across every slope. Then we write down the work the roof needs: tear-off, decking, underlayment, flashing, shingles, ventilation, and gutters.

On a leak repair, we trace the water. A stain on the ceiling is often several feet from the hole, because water runs along rafters and the deck before it drips. We follow the trail in the attic back to the entry point, open the roof there, and fix the flashing, shingle, or boot that failed.

We walk you through our findings on the shingles, deck, underlayment, and flashing. Then we compare repair and replacement options and recommend the one that fits your roof.

We agree on a start date, an arrival time, and driveway access for the dumpster and equipment. We nail shingles in the pattern the manufacturer specifies, because the wrong nail placement lets wind lift the tabs. We install ridge vent and confirm the soffits are open to feed it. At the end of the day, we clear debris and sweep the yard and driveway for roofing nails. When the roof is done, we walk it again for a post-installation inspection and give you before and after photos. Our roofing project process guide walks through each day of the job.

Close-up of a brick chimney base on an asphalt shingle roof with lifted counter flashing and cracked mortar joints.

Frequently Asked Questions

Can you repair my roof instead of replacing it?

Yes, when the damage is local and the rest of the roof is sound. A few missing shingles, a cracked pipe boot, or failed chimney flashing is a repair. If shingles are losing granules and curling on every slope, or the deck is soft in several places, we recommend replacement and show you the photos of what we found.

Can you put new shingles over my old roof?

We check first. If the roof has one layer, the deck is solid, and the flashing is in good shape, an overlay can work. If the roof already has two layers, the deck is soft, or ice dams have been a problem, we tear off. Ice and water shield has to go on the bare deck to do its job.

How do you stop ice dams on my house?

We seal the eaves with ice and water shield so backed-up water stays out. Then we fix the cause in the attic by clearing blocked soffit vents and balancing intake with ridge exhaust. We also clear and re-pitch the gutters so meltwater drains off the roof.

Do you handle the permit in Wallingford?

Yes. We prepare the permit paperwork for replacement work through Wallingford's building department and schedule your start date around it.

What affects the price of a new roof?

Roof size, pitch, number of layers to tear off, decking repairs, flashing, ventilation, and the roofing material all change the price. We measure the roof and inspect those conditions before we write the estimate. Our roofing cost guide explains each one.

Request an Estimate

Call (475) 381-2544 or request an estimate for roofing work in Wallingford. Tell us where the roof is leaking, where shingles are missing, or where ice builds up in winter. We will inspect the roof and attic, photograph what we find, and put the recommended work in writing. We also work in nearby North Haven, Cheshire, and Hamden. Learn more about our family company.

Tony G., New Haven, Roof Repair ★★★★★

Had a leak over the back bedroom. They found the problem, replaced the bad section and that was it. No sales pitch for a whole new roof.